[Archive] Can't Extract Vmaps??
[Archive] Can't Extract Vmaps??
Archived author: bloodthunder69 • Posted: 2025-11-04T18:15:41.067689
Original source
Greetings EmuCoach community!
Recently I recompiled a new trinitycore. Everything went smoothly, until I started the map extraction step. The map extractor worked perfectly fine, but as I moved onto the vmap extractor, it didn't quite work out...
As i started it up and waited patiently for it to finish, it suddenly closed. Thinking it had just finished I attempted to start up the vmap assembler, but it refused to work. I ran the vmap extractor again with a clean set of files and managed to get a screenshot of the error message right before it closed again.
View attachment Capture.JPG
I have looked everywhere for a post about this but I cannot find one anywhere. If anyone could offer a solution to my proble, I would greatly appreciate it. Until then, my new trinitycore project has to be put on hold. Thanks guys!
Archived author: bloodthunder69 • Posted: 2025-11-04T18:15:41.067689
Original source
There are a few posts about this actually. Check this out:
https://github.com/TrinityCore/TrinityCore/issues/10195
https://community.trinitycore.org/topic/...ms/?page=4
Best Regards.